![]() Switchable resolution bandpass filters for both ranges between 2.6kHz and 640kHz. Spectrum Analyzer with two inputs, high quality MF/HF/VHF input for 0.1MHZ-350MHz, lesser quality UHF input for 240MHz-960MHz. The input/output specification of the tinysa is split over the 4 modes: Low input mode, High input mode, Low output mode, High output mode. Color display showing 290 scan points covering up to the full low or high frequency range The tinysa contains all the components of a conventional heterodyne swept spectrum analyzer. Built-in calibration signal generator that is used for automatic self test and low input calibration. When not used as Spectrum Analyzer it can be used as Signal Generator, MF/HF/VHF sinus output between 0.1MHZ-350MHz, UHF square wave output between 240MHz-960MHz. A scan from 0MHz to 350MHz with an RBW of 10kHz takes about 2 minutes. ![]() ![]() But with increase of the frequency span and decrease of the RBW the scanning speed decreases quickly. The fastest scanning speed occurs with an RBW or 300kHz or wider and is about 2 scans per second. This resolution filter is swept across the desired frequency range. Spectrum analyzers like the tinysa use a resolution filter that is used to isolate the input power in a small frequency range. NOTE: Due to the old inventory might mix with the new batch, and If you got the old version TinySA and want a new one, you could apply a replacement for it. Produced by Hugen, tinysa with latest firmware V0.3.1, the displayed version info is "ESD protected" meaning the diodes are installed which will be more stable and sensitive with higher antistatic level and longer service life. If your tinysa missed the antenna, please do contact AURSINC.
0 Comments
Leave a Reply. |